2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

CAN System Specification Chart: Notes

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Determine CAN system type from the following specification chart. Then choose the correct diagnosis sheet.

NOTE: Refer to "CHECK OF CAN SYSTEM TYPE (HOW TO USE CAN SYSTEM TYPE SPECIFICATION CHART) " for how to use CAN system specification chart.
CAN SYSTEM SPECIFICATION CHART

Axle 2WD
Engine VQ35DE
Transmission A/T
Brake control TCS VDC
Automatic drive positioner - - - X
Color display - X X X
Monochrome display X - - -
CAN system type 1 2 3 4
Diagnosis sheet CAN SYSTEM (TYPE 1)  CAN SYSTEM (TYPE 2)  CAN SYSTEM (TYPE 3)  CAN SYSTEM (TYPE 4) 
CAN communication signal chart "TYPE 1/TYPE 2 " "TYPE 3/TYPE 4 "
X: Applicable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.