Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Center Console Assembly: Disassembly

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove center console. Refer to "REMOVAL ".
Remove front bin assembly.

Fig 1: Identifying Front Bin Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove rear console trim cover.

Fig 2: Identifying Rear Console Trim Cover
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove RH and LH console side trim panels.

Fig 3: Identifying RH And LH Console Side Trim Panels
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove storage bin door assembly.

Fig 4: Identifying Storage Bin Door Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove screws and split RH from LH case.

Fig 5: Identifying Screws And Split RH
Courtesy of NISSAN MOTOR CO., U.S.A.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.