2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Checking Brake Fluid Level

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  • Check fluid level in the sub tank. It should be between "MAX" and "MIN" lines on the sub tank.
  • Visually check around the reservoir tank and sub tank for leaks.
  • If fluid level is extremely low, check brake system for leaks.
  • Release parking brake lever and see if brake warning lamp goes off. If not, check brake system for leaks.
    Fig 1: Locating Brake Fluid Level
    G04906688Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.