Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Bleeding Brake System
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Carefully monitor brake fluid level at the sub tank during bleeding operation.
- Fill the sub tank with new brake fluid. Refer to "FLUIDS AND LUBRICANTS ". Make sure it is full at all times while bleeding the air out of system.
- Place a container under the sub tank to avoid spilling brake fluid.
- Do not loosen the line fittings at the ABS actuator during air bleeding.
- Turn ignition switch OFF and disconnect ABS actuator and control unit connector or negative battery terminal.
- Connect a transparent vinyl tube and container to air bleeder valve.
- Fully depress brake pedal several times.
- With brake pedal depressed, open air bleeder valve to release air.
- Close air bleeder valve.
- Release brake pedal slowly.
- Tighten air bleeder valve to specification.
Air bleeder valve : 8 N.m (0.8 kg-m, 71 in-lb)Β
- Repeat steps Β 2 through Β 7 until no more air bubbles come out of air bleeder valve.
- Bleed the brake hydraulic system air bleeder valves in the following order:
Right rear brake --> Left front brake --> Left rear brake --> Right front brake
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
