2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Preliminary Check

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK WARNING INDICATOR ILLUMINATION 
    1. Turn ignition switch ON.
    2. Make sure warning indicators (such as malfunction indicator lamp and oil pressure warning indicator) illuminate.

    Do warning indicators illuminate? 

    YES: GO TO 2.

    NO: Check ignition power supply system of combination meter. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

  2. CHECK OPERATION OF SELF-DIAGNOSIS MODE (COMBINATION METER) 

    Perform self-diagnosis mode of combination meter. Refer to "SELF-DIAGNOSIS MODE OF COMBINATION METER ".

    Does self-diagnosis mode operate normally? 

    YES: GO TO 3.

    NO: Check combination meter power supply and ground circuit. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

  3. CHECK ODOMETER OPERATION 

    Check segment display status of odometer.

    Fig 1: Checking Odometer Operation
    G04896538

    Is the display normal? 

    YES: GO TO 4.

    NO: Replace the combination meter. Refer to "COMBINATION METER ".

  4. CHECK COMBINATION METER CIRCUIT 

    Check operation of each meter/gauge in self-diagnosis mode.

    OK or NG 

    OK: GO TO 5.

    NG: Replace the combination meter. Refer to "COMBINATION METER ".

  5. CHECK SELF-DIAGNOSTIC RESULTS OF METER 

    Select "METER" on CONSULT-II and perform self-diagnosis of meter.

    Self-diagnostic results content 

    CAN COMM CIRC [U1000]: Refer to "DTC [U1000] CAN COMMUNICATION CIRCUIT ".

    VEHICLE SPEED CIRC [B2205]: Refer to "DTC [B2205] VEHICLE SPEED CIRCUIT ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.