Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch: Description
The power window regulator master switch controls the driver side power window and activates the driver side power window motor. If a malfunction is found in the pulse sensor during motor operation, the fail-safe function will stop UP/DOWN operation.
If the AUTO UP/DOWN function does not operate, the cause may be one or more of the following:
- The recorded power window fully closed position, which is stored in the power window regulator master switch, was erased as a result of the battery terminal cable or the power window regulator master switch connector being disconnected.
- The pulse sensor in the power window regulator motor has a malfunction.
- The wiring between the power window regulator master switch and the corresponding power window regulator motor is open or short circuit.
- The power window regulator master switch has a malfunction.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.