2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Combination Meter: Removal

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE METER HOOD SUB-ASSEMBLY 
    1. Tilt the steering column assembly down as far as possible.
    2. Using a moulding remover, detach the 9 claws.

      HINT:

      Tape the moulding remover tip before use.

    3. Remove the meter hood.
    Fig 1: Detaching 9 Claws Using Moulding Remover
    G04224370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the screw and detach the 2 claws.
    2. Remove the combination meter and disconnect the connectors.
    Fig 2: Removing Combination Meter Assembly
    G04224371Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE COMBINATION METER GLASS 
    1. Detach the 8 claws, and then remove the combination meter glass.
      Fig 3: Removing Combination Meter Glass
      G04224372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.