Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Fuel Lid Lock Control: Removal
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
- Remove the screw.
- Remove the cover in the direction indicated by the arrow mark in the illustration.
- Remove the cable.
- REMOVE FRONT SEAT ASSEMBLY LH
- Remove the front seat (see REMOVAL ).
- REMOVE TONNEAU COVER ASSEMBLY
- REMOVE DECK BOARD SUB-ASSEMBLY
- REMOVE NO. 1 DECK BOARD (See REMOVAL )
- REMOVE REAR NO. 1 FLOOR BOARD (See REMOVAL )
- REMOVE REAR SEAT CUSHION ASSEMBLY (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY LH (See REMOVAL )
- REMOVE FRONT DOOR SCUFF PLATE LH (See REMOVAL )
- REMOVE NO. 1 SIDE TRIM ASSEMBLY LH (See REMOVAL )
- REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
- Remove the floor mat.
HINT:
It is not necessary to fully remove the floor mat. Partially remove it so that the cable can be removed later.
- Remove the cable from the clamps as shown in the illustration.
- Detach the claws and remove the cable.
- Remove the floor mat.
- REMOVE FUEL FILLER OPENING LID LOCK RETAINER
- Remove the lock retainer as shown in the illustration.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
