2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Rear Combination Light Assembly: Reassembly

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY 
    1. Attach the clamp and install the rear combination light socket and wire.
  2. INSTALL REAR COMBINATION LIGHT BODY GASKET LH 
  3. INSTALL REAR TURN SIGNAL LIGHT BULB 
    1. Install the light bulb to the light socket.
    2. Install the light socket.
    Fig 1: Attaching Clamp
    G04224175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL BACK-UP LIGHT BULB 
    1. Install the light bulb to the light socket.
    2. Install the light socket.
  5. INSTALL TAIL AND STOP LIGHT BULB 
    1. Install the light bulb to the light socket.
    2. Install the light socket.
  6. INSTALL REAR BUMPER SIDE BRACKET LH 
    1. Install the rear bumper side bracket to the rear combination light.
      Fig 2: Installing Rear Bumper Side Bracket To Rear Combination Light
      G04224176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002


HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. INSTALL LICENSE PLATE LIGHT LENS 
  2. INSTALL LICENSE PLATE LIGHT BULB 
    1. Install the license plate light bulb to the license plate light socket.
    2. Install the light bulb, light socket and wire as a unit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.