Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Rear Combination Light Assembly: Installation
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- INSTALL REAR COMBINATION LIGHT ASSEMBLY LHÂ
- Install the pin, and then install the rear combination light assembly LH.
- Install the 3 nuts.
- Connect the connector.
- INSTALL REAR FLOOR SERVICE HOLE COVERÂ
- Install the rear floor service hole cover.
- INSTALL REAR BUMPER COVER (See  INSTALLATION )Â
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ
- PERFORM INITIALIZATIONÂ
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- INSTALL LICENSE PLATE LIGHT ASSEMBLYÂ
- Attach the 2 claws and install the license plate light assembly.
- Connect the connector.
- INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDEÂ
- INSTALL BACK DOOR SIDE GARNISH RH (See  REASSEMBLY )Â
- INSTALL BACK DOOR SIDE GARNISH LH (See  REASSEMBLY )Â
- INSTALL BACK DOOR GARNISH CENTER (See  REASSEMBLY )Â
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ
- PERFORM INITIALIZATIONÂ
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
