2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Rear Combination Light Assembly: Disassembly

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. REMOVE REAR SIDE BRACKET LH 
    1. Using needle nose pliers, detach the claws and remove the rear bumper side bracket from the rear combination light assembly.
    Fig 1: Detaching Claws
    G04224170Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE TAIL AND STOP LIGHT BULB 
    1. Remove the light socket as shown in the illustration.
    2. Remove the light bulb from the light socket.
    Fig 2: Removing Light Socket
    G04224171Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE BACK-UP LIGHT BULB 
    1. Remove the light socket as shown in the illustration.
    2. Remove the rear combination light bulb from the light socket.
    Fig 3: Removing Back-Up Light Bulb
    G04224172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR TURN SIGNAL LIGHT BULB 
    1. Remove the light socket as shown in the illustration.
    2. Remove the rear combination light bulb from the light socket.
  5. REMOVE REAR COMBINATION LIGHT BODY PACKING LH 
    Fig 4: Removing Rear Combination Light Body Packing LH
    G04224173Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY 
    1. Detach the clamp and remove the rear combination light socket and wire.
      Fig 5: Detaching Clamp
      G04224174Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002


HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. REMOVE LICENSE PLATE LIGHT ASSEMBLY 
    1. Disconnect the connector.
    2. Detach the 2 claws and remove the license plate light as shown in the illustration.
    Fig 1: Removing License Plate Light
    G04224177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE LICENSE PLATE LIGHT BULB 
    1. Turn in the direction indicated by the arrow and remove the license plate light bulb, and the license plate light socket and wire as a unit.
    2. Remove the license plate light bulb from the license plate light socket and wire.
  3. REMOVE LICENSE PLATE LIGHT LENS 
Fig 2: Removing License Plate Light Bulb
G04224178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.