Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Map Light Assembly: Inspection
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT MAP LIGHT ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard resistance
CONNECTOR TERMINAL RESISTANCE SPECIFICATIONSTester Connection Condition Specified Condition 3 - 4
3 - 8Switch is OFF 10 kΩ or higher - Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 8, and then check that the light comes on when the switch is in the DOOR position.
OK: Light comes on.
- Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 4, and then check that the light comes on when the switch is in the ON position.
OK: Light comes on.
- Measure the resistance according to the value(s) in the table below.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
