2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Lighting System: Precaution

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
SYSTEM REFERENCE

System See Procedure
Power window control system INITIALIZATION
Sliding roof system INITIALIZATION
  1. PRECAUTION OF HEADLIGHT BULB REPLACEMENT 
    1. If even a thin film of oil is left on the surface of the halogen light, its service life will be shortened because the light will burn at a higher temperature.
    2. Handle any halogen light with great care. Dropping, hitting or damaging the bulb, in any way, may result in it exploding and shattering because the internal pressure is high.
    3. Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for too long.
    4. Always use a bulb of the same wattage for replacement.
    5. Firmly reinstall the socket after bulb replacement. The lens may become cloudy or the light cavity may be filled with water through the gaps around the socket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.