2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Headlight Assembly: Repair

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. INSTALL HEADLIGHT PROTECTOR RETAINER UPPER LHΒ 

    HINT:

    • If the installation area of the headlight is damaged, use the supply bracket for low-cost repair.
    • Ensure that the headlight assembly is not damaged.
      1. Cut off the part shaded in the illustration and smooth with sandpaper.
        NOTE: After cutting off the part, place the headlight protector retainer upper against the bosses and gradually file away until installation is possible.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.