Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Headlight Assembly: Reassembly
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- INSTALL HEADLIGHT CORD LH
- Attach the 3 clamps to install the headlight cord LH.
- INSTALL FRONT SIDE MAKER LIGHT BULB
- Install the front side maker light bulb to the socket.
- Install the front side maker light socket.
- INSTALL CLEARANCE LIGHT BULB
- Install the clearance light bulb to the front socket.
- Install the clearance light socket.
- INSTALL FRONT TURN SIGNAL LIGHT BULB
- Install the front turn signal light bulb to the socket.
- Install the front turn signal light socket.
- INSTALL NO. 2 HEADLIGHT BULB
- INSTALL NO.1 HEADLIGHT BULB
- INSTALL HEADLIGHT ASSEMBLY LH
- Connect the connectors, and attach the claw to install the headlight assembly LH.
- Install the 2 screws and bolt.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
