2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Back-Up Light Switch: Inspection

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Back-Up Light Switch Connector Terminals
      G04224205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

    CONNECTOR TERMINAL RESISTANCE SPECIFICATIONS

    Tester Connection Condition Specified Condition
    1 - 2 OFF 10 kΩ or higher
    1 - 2 ON Below 1 Ω
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.