Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Service Data

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

PARKING BRAKE SERVICE DATA SPECIFICATION

Paring brake lever travel at 196 N (20 kgf, 44.1 lbf)	Standard	6 to 9 clicks
Rear disc inside diameter	Standard	173 mm (6.81 in.)
	Maximum	174 mm (6.85 in.)
Parking brake shoe lining thickness	Standard	3.2 mm (0.126 in.)
	Minimum	1.0 mm (0.039 in.)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.