Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
DRIVE SHAFT TORQUE SPECIFICATIONS
| Part Tightened | N.m | kgf.cm | ft. lbf |
|---|---|---|---|
| Front wheel | 103 | 1,050 | 76 |
| front suspension lower arm x lower ball joint. | 89 | 908 | 66 |
| Tie rod end x Steering knuckle | 49 | 500 | 36 |
| Front axle hub nut | 216 | 2,200 | 159 |
| Drive shaft bearing case mounting bolt | 64 | 650 | 47 |
| Front speed sensor set bolt | 8.0 | 82 | 71 48 in.lbf |
| Front stabilizer Link assembly x Shock absorber | 74 | 755 | 55 |
| Flexible hose and speed sensor wire harness x Shock absorber | 19 | 194 | 14 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.