Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Brake pedal
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
BRAKE PEDAL TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft. lbf |
|---|---|---|---|
| Clevis lock nut | 26 | 265 | 19 |
| Stop light switch assembly x Stop light switch mounting adjuster | 1.5 | 15 | 13 48 in.lbf |
| Brake pedal sub-assembly x Brake pedal support sub-assembly | 37 | 375 | 27 |
| Brake pedal support sub-assembly | 12.7 | 130 | 9 |
| Brake pedal support sub-assembly | 24 | 241 | 17 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.