Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
2AZ-FE CHARGING TORQUE SPECIFICATION
| Part Tightened | N.m | kgf.cm | ft. lbf |
|---|---|---|---|
| Wire harness clamp bracket x Generator assembly | 8.4 | 85 | 74 48 in.lbf |
| Generator wire x Generator assembly : for bolt A | 21 | 215 | 16 |
| Generator wire x Generator assembly : for bolt B | 52 | 530 | 38 |
| Generator wire x Generator assembly | 9.8 | 100 | 7 |
| Generator rectifier end frame x Generator drive end frame | 5.8 | 60 | 51 48 in.lbf |
| Cord clip x Generator rectifier end frame | 4.56 | 45 | 40 48 in.lbf |
| Generator brush holder assembly x Generator rectifier end frame | 1.76 | 15 | 16 48 in.lbf |
| Generator rear end cover x Generator rectifier end frame | 4.6 | 45 | 41 48 in.lbf |
| Generator pulley x Generator rotor assembly | 110.3 | 1,125 | 82 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
