2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Service Data

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
2AZ-FE CHARGING SERVICE DATA SPECIFICATION

Battery Standard voltage 12.5 to 12.9 V at 20Β°C (68Β°F)
Charging circuit without load Standard amperage 10 A or less at 2,000 RPM
Standard voltage 13.2 to 14.8 V at 2,000 RPM
Charging circuit with load Standard amperage 30 A or more
Generator brush holder assembly Brush length Standard length 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum length 4.5 mm (0.177 in.)
Generator rotor assembly Standard resistance Slip ring 2.3 to 2.7 Ξ© at 20Β°C (68Β°F)
Slip ring - Rotor core 10 kΞ© or higher
Slip ring diameter Standard diameter 14.2 to 14.4 mm (0.559 to 0.567 in.)
Minimum diameter 14.0 mm (0.551 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.