2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

CONSULT-II Start Procedure

WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Turning ignition switch off when performing CAN diagnosis could cause CAN memory to be erased.
  1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
    Fig 1: Connecting CONSULT-II And CONSULT-II CONVERTER To Data Link Connector
    G04202050Courtesy of NISSAN MOTOR CO., U.S.A.
  2. If necessary, turn on the ignition switch.
  3. Touch "START (NISSAN BASED VHCL)" or "System Shortcut" eg: ENGINE) on the screen.
    Fig 2: Consult-II Display Screen
    G04151184Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.