Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Front Floor Footrest: Replacement
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FRONT FLOOR FOOTREST
- Holding the floor mat, disengage clips from the upper with a screwdriver to remove the front floor footrest.
HINT:
Tape the screwdriver tip before use.
NOTE: Warm the inside of the vehicle well before removal. - Disengage the footrest clips, and then remove the 2 clips from the front floor footrest.
- Holding the floor mat, disengage clips from the upper with a screwdriver to remove the front floor footrest.
- INSTALL FRONT FLOOR FOOTREST
- Install the footrest clips by engaging the claws with the front floor footrest.
- Before installation, check that the part to be engaged with the clips of front floor footrest is not damaged.
NOTE: If it is damaged, replace it with a new one.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.