Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
CONSULT-II Function (ABS): Notes
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
CONSULT-II FUNCTION
| ABS diagnostic mode | Description |
|---|---|
| WORK SUPPORT | Supports inspection and adjustments. Commands are transmitted to the ABS actuator and electric unit (control unit) for setting the status suitable for required operation, input/output signals are received from the ABS actuator and electric unit (control unit) and received data is displayed. |
| SELF-DIAG RESULTS | Displays ABS actuator and electric unit (control unit) self-diagnosis results. |
| DATA MONITOR | Displays ABS actuator and electric unit (control unit) input/output data in real time. |
| CAN DIAG SUPPORT MNTR | The result of transmit/receive diagnosis of CAN communication can be read. |
| ACTIVE TEST | Operation of electrical loads can be checked by sending drive signal to them. |
| FUNCTION TEST | Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". |
| ECU PART NUMBER | ABS actuator and electric unit (control unit) part number can be read. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.