Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 175 (Electrical Component Locator): Switches
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| ASCD Brake Switch | Above brake pedal, on bracket. See Figure. |
| Back Door Switch | At lower center of back door. |
| Brake Fluid Level Switch | On master cylinder fluid reservoir. See Figure. |
| Hood Switch | At left front of engine compartment. See Figure. |
| Oil Pressure Switch | On lower right front of cylinder block. See Figure. |
| Parking Brake Switch | Behind left side of dash. See Figure. |
| Park/Neutral Position Switch | Integral to CVT unit. |
| Stoplight Switch | Above brake pedal, on bracket. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
