Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 175 (Electrical Component Locator): Grounds
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION
| Component | Component Location |
|---|---|
| B7 | Behind left kick panel. |
| B15 | At base of left "B" pillar. |
| B20 | Behind left rear seat. |
| B105 | Behind right kick panel. |
| B113 | At base of right "B" pillar. |
| B116 | Behind right rear seat. |
| E13 | At left front corner of engine compartment. See Figure. |
| E26 | At lower right side of engine compartment. See Figure. |
| E28 | At right side of engine compartment. See Figure. |
| E29 | At right side of engine compartment. See Figure. |
| F23 | On front of engine. See Figure. |
| M14 | Behind left end of dash. See Figure. |
| M78 | Behind right end of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.