2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Setting Change Function

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

The settings of the automatic driving positioner system can be changed, using CONSULT-II and the display in the center of the instrument panel.

AUTOMATIC DRIVING POSITIONER SETTING CHANGE FUNCTION

x: Applicable -: Not applicable
Setting item Content CONSULT-II (WORK SUPPORT) Display unit Default setting Factory setting
SEAT SLIDE
VOLUME SET		 The distance at exiting operation can be selected from the following 3 modes. 40 mm - x x
80 mm - -
150 mm - -
Sliding Front Seat When Entry/ Exiting Vehicle The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated) ON ON: Indicator lamp ON - x
OFF OFF: Indicator lamp OFF x -
Reset custom settings* All settings to default. - Default: Setting button ON - -

It is possible to set sliding front seat for entry/exit of vehicle by pressing set switch.

SLIDING FRONT SEAT FOR ENTRY/EXIT SETTING CHANGE FUNCTION

Content Setting change operation Indicator LEDs
The seat sliding turnout and return at entry/exit can be operated. Press the set switch for more than 10 seconds Blinking twice
The seat sliding turnout and return at entry/exit can be not operated. Blinking once
*: Setting of sliding front seat for entry/exit of vehicle is ON at factory-shipment. But if custom settings are reset, setting turns OFF.
NOTE: After the setting is registered, the new setting is effective, even if the battery is disconnected.
Chapter Navigation
Return to Chapter: Preliminary Check
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.