Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Rear Disc Brake
WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
REAR DISC BRAKE SPECIFICATIONS
| Unit: mm (in) | ||
|---|---|---|
| Brake model | CLZ14VB | |
| Brake pad | Standard thickness (new) | 11.0 mm (0.433 in) |
| Repair limit thickness | 2.0 mm (0.079 in) | |
| Disc rotor | Standard thickness (new) | 18.0 mm (0.709 in) |
| Repair limit thickness | 16.0 mm (0.630 in) | |
| Maximum uneven wear (measured at 8 positions) | 0.015 mm (0.0006 in) | |
| Runout limit (with it attached to the vehicle) | 0.07 mm (0.0028 in) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.