2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
CIRCUIT PROTECTION DEVICES LOCATION

Component Component Location
Engine Room Box In right side of engine compartment. See Figure .
Fuse Block In fuse, fusible link & relay block (J/B). See Figure .
Fuse Block (J/B) No. 1 Behind left end of dash. See Figure .
Fuse Block (J/B) No. 2 Behind right kick panel. See Figure .
Fuse, Fusible Link & Relay Block (J/B) At right side of engine compartment. See Figure .
Fuse, Fusible Link & Relay Box At right side of engine compartment, in engine room box.
Fusible Link In fuse, fusible link & relay block (J/B). See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.