2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Control Units

WARNING: This page is about a different car, the 2003 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
CONTROL UNITS LOCATION

Component Component Location
Air Bag Diagnosis Sensor Unit Under rear of center console. See Figure.
Body Control Module Behind left kick panel. See Figure.
Daytime Light Control Unit (Canada) At right front corner of engine compartment. See Figure.
Display & A/C Auto Amplifier On top center of dash. See Figure.
Driver Seat Control Unit Under driver seat. See Figure.
Engine Control Module Behind right kick panel. See Figure.
NATS Antenna Amplifier Behind left center of dash. See Figure.
NAVI Control Unit In upper glove box. See Figure.
Transmission Control Module Behind right kick panel. See Figure.
VDC Actuator At left rear corner of engine compartment. See Figure.
VDC/TCS/ABS Control Unit Behind left side of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.