Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
2WD Model
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS (2WD MODEL)
| Applied model | VK56DE | |
| Body | King cab | Crew cab |
| Propeller shaft model | 2S1350 | 3S1350 |
| Number of joints | 2 | 3 |
| Coupling method with rear final drive | Flange type | Flange type |
| Coupling method with transmission | Sleeve type | Sleeve type |
| Shaft length (Spider to spider) | 1619 mm (63.74 in) | 869 mm (34.21in) (front shaft) |
| 1209 mm (47.60 in) (rear shaft) | ||
| Shaft outer diameter | 127.6 mm (5.02 in) | 88.9 mm (3.50 in) |
| Journal axial play | 0.02 mm (0.0008 in) or less | |
| Propeller shaft runout limit | 1.02 mm (0.0402 in) or less | 0.6 mm (0.24 in) or less |
| Propeller shaft joint flex effort | 2.26 N.m (0.23 kg-m, 20 in-lb) or less | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
