Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

GENERAL SPECIFICATIONS

Applied model

2WD

4WD

Automatic transmission model

RE5R05A

Transmission model code number

95X1C

95X1D

Stall torque ratio

2.0: 1

Transmission gear ratio

1st

3.827

2nd

2.368

3rd

1.520

4th

1.000

5th

0.834

Reverse

2.613

Recommended fluid

NISSAN Matic Fluid J⁽¹⁾

Fluid capacity

10.6 liter (11-1/4 US qt, 9-3/8 Imp qt)

CAUTION:

Use only Genuine NISSAN ATF Matic Fluid J. Do not mix with other fluid.
Using automatic transmission fluid other than Genuine NISSAN ATF Matic Fluid J will deteriorate in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the warranty.

⁽¹⁾	Refer to "FLUIDS AND LUBRICANTS ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.