2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

General Precautions for Service Operations

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
  • Never work with wet hands.
  • Xenon headlamp includes high voltage generating part. Be sure to disconnect battery negative cable (negative terminal) or power fuse before removing, installing, or touching the xenon headlamp (including lamp bulb).
  • Turn the lighting switch OFF before disconnecting and connecting the connector.
  • When turning the xenon headlamp on and while it is illuminated, never touch the harness, bulb, and socket of the headlamp.
    Fig 1: Warning Xenon Headlamp
    G02405465Courtesy of NISSAN MOTOR CO., U.S.A.
  • When checking the headlamp on/off operation, check it on vehicle and with the power connected to the vehicle-side connector.
  • Do not touch the headlamp bulb glass surface with bare hands or allow oil or grease to get on it. Do not touch the headlamp bulb just after the headlamp is turned off, because it is very hot.
  • Install the xenon headlamp bulb socket correctly. If it is installed improperly, high-voltage leak or corona discharge may occur that can melt the bulb, connector, and housing. Do not illuminate the xenon headlamp bulb out of the headlamp housing. Doing so can cause fire and harm your eyes.
  • When the bulb has burned out, wrap it in a thick vinyl bag and discard. Do not break the bulb.
  • Leaving the bulb removed from the headlamp housing for a long period of time can deteriorate the performance of the lens and reflector (dirt, clouding). Always prepare a new bulb and have it on hand when replacing the bulb.
    Fig 2: Warning High Voltage Xenon Lamp Ballast Label
    G02405466Courtesy of NISSAN MOTOR CO., U.S.A.
  • When adjusting the headlamp aiming, turn the aiming adjustment screw only in the tightening direction. (If it is necessary to loosen the screw, first fully loosen the screw, and then turn it in the tightening direction.)
  • Do not use organic solvent (paint thinner or gasoline) to clean lamps and to remove old sealant.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.