2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove steering column shaft lock nut, then remove steering column shaft from front side of jacket tube.
  2. Remove tilt device from jacket tube.
  3. Remove lock nut and adjusting stopper according to the following procedure.
  1. Turn tilt lever to the unlock side.
  2. Remove spring from column mounting bracket.
    Fig 1: Removing Tilt Device From Jacket Tube
    G02409104Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Lock adjusting bolt, then remove lock nut.
    Fig 2: Locking Adjusting Bolt
    G02409105Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove adjusting bolt, adjusting stopper, column mounting bracket, tilt lever stopper and tilt lever from jacket tube.
    Fig 3: Removing Lock Bolt
    G02409106Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.