Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Control Device Removal and Installation: Removal
WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect lower lever of control device and control rod.
- Remove knob cover below selector lever downward.
- Pull lock pin out of selector lever knob.
- Remove selector lever knob.
- Remove console finisher (A/T ring) and console finisher.
- Refer to "COMPONENT PARTS DRAWING ".
- Remove center console.
- Refer to "COMPONENT PARTS DRAWING ".
- Remove key interlock cable from control device.
- Refer to "REMOVAL AND INSTALLATIONΒ ".
- Disconnect A/T device harness connector.
- Remove control device assembly.CAUTION: Do not impact, or damage propeller shaft tube.Β
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
