2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
General Specifications Chart

Applied model VQ35DE engine
Automatic transmission model RE5R05A
Transmission model code number 92X60
Stall torque ratio 2.0: 1
Transmission gear ratio 1st 3.540
2nd 2.264
3rd 1.471
4th 1.000
5th 0.834
Reverse 2.370
Recommended fluid Genuine Nissan Matic J ATF(1)
Fluid capacity 10.3 liter (10-7/8 US qt, 9-1/8 lmp qt)
CAUTION:
  • Use only Genuine Nissan Matic J ATF. Do not mix with other fluid.
  • Using A/T fluid other than Genuine Nissan Matic J ATF will deteriorate in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the warranty.
(1) Refer to MA-12. "Fluids and Lubricants"Β  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.