Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK GROUND CONNECTIONSÂ
- Turn ignition switch OFF.
- Loosen and retighten three ground screws on the body. Refer to "GROUND INSPECTIONÂ ".
OK or NG
- OK: GO TO 2.
- NG: Repair or replace ground connections.
- CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUITÂ
- Disconnect "fuel level sensor unit and fuel pump" harness connector.
- Turn ignition switch ON.
- Check voltage between "fuel level sensor unit and fuel pump" terminal 4 and ground with CONSULT-II or tester.
- Voltage: Approximately 5VÂ
OK or NG
- OK: GO TO Â 4.
- NG: GO TO 3.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M72, F102
- Harness connectors B1, M12
- Harness for open or short between ECM and "fuel level sensor unit and fuel pump"
- : Repair open circuit or short to ground or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch OFF.
- Disconnect "unified meter and A/C amp." harness connector M49.
- Check harness continuity between "fuel level sensor unit and fuel pump" terminal 5 and "unified meter and A/C amp." terminal 36. Refer to WIRING DIAGRAMÂ .
- Continuity should exist.Â
- Also check harness for short to power.
OK or NG
- OK: GO TO Â 6.
- NG: GO TO 5.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors B1, M12
- Harness for open or short between "fuel level sensor unit and fuel pump" and "unified meter and A/C amp."
- : Repair open circuit or short to ground or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSORÂ
Refer to "COMPONENT INSPECTIONÂ ".
OK or NG
- OK: GO TO 7.
- NG: Replace fuel level sensor unit.
- CHECK INTERMITTENT INCIDENTÂ
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ ".
- : INSPECTION ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
