WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Start engine and warm it up to normal operating temperature.
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.

Fig 1: Scan Tool Display "Select Work Item, Idle Air Vol Learn"
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START" and wait 20 seconds.

Fig 2: Scan Tool Display "Work Support"
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that "CMPLT" is displayed on CONSULT-II screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the DIAGNOSIS PROCEDURE below.
Rev up the engine 2 or 3 times and make sure that idle speed and ignition timing are within the specifications.

Fig 3: Scan Tool Display "Work Support, Idle Air Vol Learn"

Courtesy of NISSAN MOTOR CO., U.S.A.

ITEM SPECIFICATION

ITEM	SPECIFICATION
Idle speed	A/T: 650+/-50 rpm (in P or N position)
	M/T: 650+/-50 rpm (in Neutral position)
Ignition	A/T: 15+/-5°BTDC (in P or N Position)
	M/T: 15+/-5° BTDC (in Neutral position)

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

With CONSULT-II

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?