Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Switch Operation
WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
The system is operated by MAIN switch and four control switches, all mounted on the steering wheel.
SWITCH NAME DESCRIPTION
| No. | Switch name | Description |
|---|---|---|
| 1 | RESUME/ACCELERATE switch | Resumes set speed or increases speed incrementally. |
| 2 | SET/COAST switch | Sets desired cruise speed, reduces speed incrementally. |
| 3 | MAIN switch | Master switch to activate the system |
| 4 | CANCEL switch | Deactivates system without erasing set speed. |
| 5 | DISTANCE switch | Changes the following distance from: Long, Middle, Short |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.