2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

BCM (Body Control Module): Consult-II: Notes

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CONSULT-II performs the following functions with combination of data receiving, command and transmission using the CAN communication line from the BCM.

BCM DIAGNOSTIC TEST ITEM AND CONTENT DESCRIPTIONS

BCM diagnostic test item Check item, diagnostic test mode Content
Inspection by part Work support Changes setting of each function.
Self-diagnosis results BCM performs self-diagnosis of CAN communication and combination switch.
Data monitor Displays the input data of BCM in real time.
CAN diagnostic support monitor The result of transmit/receive diagnosis of CAN communication can be read.
Active test Gives a drive signal to a load to check the operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.