Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Items Of Each Part
WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
CONSULT-II will Only display systems the vehicle possesses.
SYSTEM AND ITEM DIAGNOSTIC TEST MODE DESCRIPTIONS
| System and item | CONSULT-II display | Diagnostic test mode (Inspection by part) | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| WORK SUPPORT | SELF-DIAG RESULTS | DATA MONITOR | CAN DIAG SUPPORT MNTR | ECU PART NUMBER | ACTIVE TEST | CONFIGURATION | ||||||
| Power door lock system | DOOR LOCK | (1) | (1) | (1) | ||||||||
| Rear window defogger | REAR DEFOGGER | (1) | (1) | |||||||||
| Warning chime | BUZZER | (1) | (1) | |||||||||
| Room lamp timer | INT LAMP | (1) | (1) | (1) | ||||||||
| Remote control entry system | MULTI REMOTE ENT | (1) | (1) | (1) | ||||||||
| Headlamp | HEAD LAMP | (1) | (1) | (1) | ||||||||
| Wiper | WIPER | (1) | (1) | (1) | ||||||||
| Turn signal lamp Hazard lamp | FLASHER | (1) | (1) | |||||||||
| Blower fan switch signal A/C switch signal | AIR CONDITONER | (1) | ||||||||||
| Combination switch | COMB SW | (1) | ||||||||||
| BCM | BCM | (1) | (1) | (1) | (1) | (1) | (1)(2) | |||||
| IVIS | IMMU | (1) | (1) | |||||||||
| Room lamp battery saver | BATTERY SAVER | (1) | (1) | (1) | ||||||||
| Trunk lid | TRUNK | (1) | (1) | |||||||||
| Vehicle security system | THEFT ALM | (1) | (1) | (1) | ||||||||
| Retained power control | RETAINED PWR | (1) | (1) | (1) | ||||||||
| Oil pressure switch | SIGNAL BUFFER | (1) | (1) | |||||||||
| Panic system | PANIC ALARM | (1) | ||||||||||
| Low tire pressure warning system | AIR PRESSURE MONITOR | (1) | (1) | (1) | (1) | |||||||
NOTE:
|
||||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
