2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Operation Procedure

WARNING: This page is about a different car, the 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.
  1. Close hood and lift wiper arms away from windshield (to prevent glass damage by wiper operation).
  2. Turn ignition switch "OFF".
  3. Turn ignition switch "ON" and, within 10 seconds, press left front door switch 10 times. Then turn ignition switch "OFF".
  4. CAUTION: Close left front door.
  5. Turn ignition switch "ON".
  6. When auto active test mode is actuated, horn chirps once, and oil pressure warning lamp starts blinking.
  7. CAUTION: Ensure to inspect "Oil Pressure Warning Lamp Stays Off (Ignition Switch On)" in appropriate INSTRUMENT PANELS article and DOOR SWITCH CHECK in ANTI-THEFT SYSTEMS - ALTIMA article, when the auto active test cannot be performed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.