Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Description: Notes
During a ran, when the engine which makes fog lamp turn on has started and parking brake is detached, foglamp turns do daytime light system for the Canada vehicle, and the light is put out at the of operating parking brake, and the of lighting switch 2ND position or the lighting switch AUTO (at the time of headlamp lighting).
ON/OFF of fog lamp switch is followed at the time of lighting switch 2ND position, and it is turned on and switched off.
An parking brake signal and engine ran or stop signal are sent to BCM (body control module) by CAN communication line, and control daytime light system.
In the state where the parking brake is not operated, if cranking time is extremely short daytime light system will light up for about 2 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
