2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Adapter Case

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the adapter case mounting bolts.
    Fig 1: Identifying Adapter Case Mounting Bolts
    G00770379Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Using a plastic hammer, tap the adapter case to remove.
  3. Remove the O-ring.
    Fig 2: Tapping The Adapter Case
    G00770380Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Using a flat-bladed screwdriver, remove the adapter case oil seal.
    CAUTION: Be careful not to damage the adapter case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.