2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Testing Condition

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  • Vehicle driven distance: More than 5, 000 km (3, 017 miles)
  • Barometric pressure: 98.3 - 104.3 kPa (1.003 -1.064 kg/cm2 , 14.25 -15.12 psi)
  • Atmospheric temperature: 20 - 30°C (68 - 86°F)
  • Engine coolant temperature: 75 - 95°C (167 - 203°F)
  • Transmission: Warmed-up After the engine is warmed up to normal operating temperature, drive vehicle until "FLUID TEMP SE" (CVT fluid temperature sensor signal) indicates more than 60°C (140°F).
  • Electrical load: Not applied Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
  • Engine speed: Idle
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.