Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Checking Radiator Cap
WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- Pull negative-pressure valve to open it, and make sure it close completely when released.
- Make sure there is no dirt or damage on the valve seat of radiator cap negative-pressure valve.
- Make sure there are no abnormalities in the opening and closing conditions of negative-pressure valve.
- Check radiator cap relief pressure.
Standard:
78 - 98 kPa (0.8 - 1.0 kg/cm2 , 11 - 14 psi)
Limit:
59 kPa (0.6 kg/cm2 , 9 psi)
- When connecting radiator cap to radiator cap tester adapter [SST] and radiator cap tester (commercial service tool), apply engine coolant to the cap seal part.
- Replace radiator cap if there is an abnormality in negative-pressure valve, or if the open-valve pressure is outside of the standard values.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
