2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

RGB Screen Is Rolling (Except NAVI Screen)

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK HARNESS 
    1. Turn ignition switch OFF.
    2. Disconnect display control unit connector and display unit connector.
    3. Check continuity between display control unit and display unit.
      CONTINUITY SPECIFICATION

      Terminals Continuity
      Display control unit (+) Display unit (-)
      Connector Terminal (Wire color) Connector Terminal (Wire color)
      M95 56 (G) M93 19 (G) Yes
    4. Check continuity between display control unit and ground.
    CONTINUITY SPECIFICATION

    Terminals Continuity
    Display control unit (+) (-)
    Connector Terminal (Wire color)
    M95 56 (G) Ground No
    Fig 1: Checking Continuity Between Display Control Unit And Ground
    G03501277Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: GO TO 2.
    2. NG: Repair harness.
  2. CHECK RGB SYNCHRONIZING SIGNAL 
    1. Connect display control unit connector and display unit connector.
    2. Turn ignition switch ON.
    3. Check signal between display unit connector M93 terminals 19 (G) and 21 with CONSULT-II or oscilloscope.
    1. 19(G)-21: Refer to TERMINALS AND REFERENCE VALUE FOR DISPLAY CONTROL UNIT .

    OK or NG

    1. OK: Replace display unit. Refer to Removal and Installation of Display Unit .
    2. NG: Replace display control unit. Refer to REMOVAL AND INSTALLATION OF DISPLAY CONTROL UNIT .
      Fig 2: Checking Signal Between Display Unit Connector M93 Terminals 19 (G) And 21
      G03501278Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.