Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
CAN Communication Unit: Notes
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Refer to the following table to determine CAN system type.
CAN COMMUNICATION UNIT SPECIFICATION
| Axle | 2WD | |||||
| Engine | VQ35DE | |||||
| Transmission | 4 A/T | 5 A/T | ||||
| Brake control | TCS | VDC | ||||
| Navigation system | - | (1) | - | (1) | ||
| Automatic drive positioner | - | - | (1) | (1) | ||
| CAN communication unit | ||||||
| ECM | (1) | (1) | (1) | (1) | ||
| TCM | (1) | (1) | (1) | (1) | ||
| ABS actuator and electric unit (control unit) | (1) | (1) | (1) | (1) | ||
| Front air control | (1) | (1) | (1) | (1) | ||
| Display control unit | - | (1) | - | (1) | ||
| Display unit | (1) | - | (1) | - | ||
| BCM | (1) | (1) | (1) | (1) | ||
| Steering angle sensor | - | - | (1) | (1) | ||
| Driver seat control unit | - | - | (1) | (1) | ||
| Data link connector | (1) | (1) | (1) | (1) | ||
| Combination meter | (1) | (1) | (1) | (1) | ||
| IPDM E/R | (1) | (1) | (1) | (1) | ||
| CAN communication type | L "TYPE 1/TYPE 2 " | L "TYPE 3/TYPE 4 " | ||||
| CAN system trouble diagnosis | 1 | 2 | 3 | 4 | ||
| CAN SYSTEM (TYPE 1) | CAN SYSTEM (TYPE 2) | CAN SYSTEM (TYPE 3) | CAN SYSTEM (TYPE 4) | |||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
