2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Setting Change Function

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

The settings of the automatic driving positioner system can be changed, using CONSULT-II and the display in the center of the instrument panel.

x: Applicable -: Not applicable

SETTING CHANGE FUNCTION

Setting item Content CONSULT-II (WORK SUPPORT) Display unit Default setting Factory setting
SEAT SLIDE VOLUME SET The distance at exiting operation can be selected from the following 3 modes. 40mm - X X
80mm - -
150mm - -
Sliding Front Seat When Entry/Exiting Vehicle The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated) ON ON: Indicator lamp ON - X
OFF OFF: Indicator lamp OFF X -
Reset custom settings() All settings to default. - Default: Setting button ON - -

It is possible to set sliding front seat for entry/exit of vehicle by pressing set switch.

SETTING CHANGE OPERATION

Content Setting change operation Indicator LEDs
The seat sliding turnout and return at entry/exit can be operated. Press the set switch for more than 10 seconds Blinking twice
The seat sliding turnout and return at entry/exit can be not operated. Blinking once
(1) Setting of sliding front seat for entry/exit of vehicle is ON at factory-shipment. But if custom settings are reset, setting turns OFF.
NOTE: After the setting is registered, the new setting is effective, even if the battery is disconnected.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.