2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

CONSULT-II Function: Notes

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

The following functions are executed by combining data received and command transmitted via the communication line from the driver seat control unit.

CONSULT-II FUNCTION

CONSULT-II diagnosis items Inspection item, self-diagnosis mode Content
AUTO DRIVE POSITIONER WORK SUPPORT(1) Changes the setting for each function.
SELF-DIAG RESULTS Check the self-diagnosis results.
DATA MONITOR CAN diagnosis support monitor Displays CAN communication system diagnosis, disabled communication status of each unit communicated with driver seat control unit.
Selection from menu Displays the input data to driver seat control unit and automatic drive positioner control unit on real-time basis.
ACTIVE TEST Gives a drive signal to a load to check the operation.
DRIVER SEAT CONTROL UNIT PART NUMBER Displays driver seat control unit part No.
BCM(2) DATA MONITOR Selection from menu Displays the input data to BCM on real-time basis
(1) For setting seat functions only.
(2) Refer to "DATA MONITOR ".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.